PWM+RGB HUB V1.5
RGB Lamp function description
1. Power on the lnitial state of the lights off
2. Short press the button light from(white),and then every time, the color of the light convesion once order (White,Blue, yellow, red ,green,orange,purple,breath, flashing ,a total of9 models)
3. Breathing pattern description, light from the light to 2 seconds, and then from light to dark 2 seconds,the color from white to start, in accordance with the white, blue,yellow, red, green,orange,purple sequential non-stop cycle.Press a button again to enter the blinking model
4. Flashing model desc,iptionc lamp to 4HZ frequency of 2 seconds afte, switching the color , In accordance with the white, blue, yellow, red ,green,orange,purple sequential non-stop cycle.Press a button to ente, the white light often bright mode.
5. In any mode, press the button fo, 3 seconds, Press the button again to enter, the white light normal bright model ,according to this cycle
Fan control function description
Before PCB board being Installed , CPU-FAN should be connected with CHA-FAN and CMOS Is set Into not to check CPU-FAN