LCD Display instruction:
1)Connect the Molex 4Pin connector with PSU
2)The display with show the following color in order-light blue,green,purple,yellow,red,purple,deep blue
3)Connect the 3pin connector on system fan-if you have in your system
4)Find the labels printed on temperature wires, connect the wire on the named parts-CPU/HDD/VGA
5)C/F-short pressing to stop light blinking, and stop one of color light.
LCD Display Function
1)Indicator for fan-Low(2,000rpm/sec),Middle(3,000rmb/sec),high(4,000rmp/sec)
2) Mode-Switch indicator for temperature, CPU/HDD/VGA--Buzzer sounds when the temperature is over than 60 degree.
3)Time indicator--can be adjusted by SET switch, After pressing <SET>,the time digit will blink, and then press<C/F> to adjust the time
4)Reset-After pressing, the TEMP display will return to CPU's centigrade mode wherever you switched to before
5)C/F-long pressing to switch Centigrade/Fahrenheit temperature（about over 1 sec)
*Avoid any pressure or any sharp touch, LCD display could be damaged.
*Do not touch by wet finger, it causes some damages
*Do not remove or change any part